Tools required: None!
(Ok, to be fair, sometimes panels may be a bit tight early on, so we provide a timber paddle to protect the shelf edge while you tap the shelf in with a hammer, mallet or old boot)
Assemble shelf on the floor, we will stand it upright later. Probably best to get a mate or family member to help out too.
Step 1: Fit lower shelf into the Side Panels.
Step 2: Fit top shelf into the Side Panels.
Step 3: Fit Brace into the base of Side Panels.
Step 4: Position the remaining shelves into your desired position.
Important: To ensure full strength and stability, the layout created must include the following minimum shelf connection requirements per side panel (including top and bottom shelf).
- H625mm: 3 x Shelf Panels
- 1225mm: 4 x Shelf Panels
- 1825mm 5 x Shelf Panels
- 2305mm 5 x Shelf Panels
Step 5: Stand shelf upright against the wall.
Step 6: (For Shelvr H1225, H1825 & H2305mm) To prevent the risk of toppling, fix the wall fixing angles provided to the upper most shelf with the self tapping screws (no drilling required), either on the top or bottom side (to minimise visibility). One wall fixing must be used per Side Panel i.e. 2 for a single bay, 3 for a double bay, etc.
Screw(s) and plug(s) for the wall are not included. Use screw(s) and plug(s) suitable for your walls. If you are uncertain, seek professional advice and installation assistance.
Warning: Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over this furniture must be used with the wall attachment device(s) provided.